Cart

No products in the cart.

Sign up

Cart

No products in the cart.

Back to Course

Laser cutting Level 1

0% Complete
0/0 Steps
  1. 0.1 Promotional Video | 介紹影片
  2. 0.2 Getting Started | 課前準備
  3. 1 Preparation | 準備工作
    1.1 Laser Cutter Basics | 雷射切割機 - 基礎知識
  4. 1.2 Laser Cutter at MakerBay | MakerBay雷射切割機 - 規格
  5. 1.3 Health and Safety | 安全注意事項
  6. 1.4 What can you make with a laser cutter? | 雷射切割機能製作出甚麼?
  7. 1.5 What material to use? | 選擇物料
  8. 2 Software | 軟件
    2.1 Supported Software and Formats | 繪圖軟件和格式
  9. 2.2 Inkscape - Edge Detection
  10. 2.3 Inkscape - Brightness Cutoff
  11. 2.4 Laser Cutting Software - Settings | 雷射切割軟件 - 設定
  12. 2.5 TriumphLaser - Settings | TriumphLaser - 設定
  13. 3 Operating the Laser Cutter | 雷射切割機的操作
    3.1 General Operation | 基本操作
  14. 3.2 MakerBay Laser Cutter - Operation | MakerBay 雷射切割機的操作
  15. 3.3 Fire | 意外起火
  16. Summary and Assignment 總結和功課
    4.1 Summary | 總結
  17. 4.2 Assignment | 功課

Participants853

Show more
Laser cutting Level 1 2.4 Laser Cutting Software – Settings | 雷射切割軟件 – 設定
In Progress
Lesson 11 of 17
In Progress

2.4 Laser Cutting Software – Settings | 雷射切割軟件 – 設定

Maria Li September 8, 2020

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.